Synth-DIY Yahoo! Groups Archives

Thread

Electrolytic V value and CGS06 output querry

2004-10-24 by ilanode

Hi list, I'm peeping here for a while and this is my first posting.
I've no EE or whatsoever background so my querry might be dumb. I'm
shopping for parts and wonder if I could replace the VOLT value of
electrolytic caps by any other value as long as it is higher than
the PSU used puts out: Can I use 47uF 16V instead of 47uF 25 V (for
the Burst Gen.)?
On the pcb of Burst Gen there is a pad CLK O is that a clock output?
Since there is no clock out mentioned in the description nor visible
on the faceplate I'm at a loss. Any help would be higly appreciated!
Thanks, Ilanode

Re: Electrolytic V value and CGS06 output querry

2004-10-24 by bbluthang

> On the pcb of Burst Gen there is a pad CLK O is that a clock

output?

the Clk O connects to the 'switch' on the clock-in jack.
if nothing is plugged into this jack, you can set the burst gen up
with the speed pot and range switch. once you plug in, this part of
the circuit is disconnected.

> I'm
> shopping for parts and wonder if I could replace the VOLT value of
> electrolytic caps by any other value as long as it is higher than
> the PSU used puts out: Can I use 47uF 16V instead of 47uF 25 V (for
> the Burst Gen.)?

if running 15v, i'd feel uncomfortable using a 16v electro for
decoupling. it is okay to go bigger than 25V. 10uF 35V or 50V would
be fine.

hope it all goes well
cheers
andrew

Re: Electrolytic V value and CGS06 output querry (thanks)

2004-10-25 by ilanode

Hi Anddrew, *many thanks*! Well, my learning curve on electronics
isn't steep. Actually I'm progressing slowly. An Analog Logic is
done and the Burst Gen will be done. Regards, Ilanode

Show quoted textHide quoted text

--- In cgs_synth@yahoogroups.com, "bbluthang" <jumpswine@h...> wrote:
>
> hi
> > On the pcb of Burst Gen there is a pad CLK O is that a clock
> output?
>
> the Clk O connects to the 'switch' on the clock-in jack.
> if nothing is plugged into this jack, you can set the burst gen up
> with the speed pot and range switch. once you plug in, this part
of
> the circuit is disconnected.
>
>
> > I'm
> > shopping for parts and wonder if I could replace the VOLT value
of
> > electrolytic caps by any other value as long as it is higher
than
> > the PSU used puts out: Can I use 47uF 16V instead of 47uF 25 V
(for
> > the Burst Gen.)?
>
> if running 15v, i'd feel uncomfortable using a 16v electro for
> decoupling. it is okay to go bigger than 25V. 10uF 35V or 50V
would
> be fine.
>
> hope it all goes well
> cheers
> andrew

Cgs synth

Electrolytic V value and CGS06 output querry

Electrolytic V value and CGS06 output querry

Re: Electrolytic V value and CGS06 output querry

Re: Electrolytic V value and CGS06 output querry (thanks)

Move to quarantaine