Hi All
just after some tips on the quper psycho, i've figured out all the wiring
etc in the most part but wanted to check what this means :
GC Glide pot center
GB Glide pot beginning
LC Level pot center
LB Level pot beginning
What is beginning? the left wiper when looking at the pot down the shaft or
from behind the pot....or something else?
Do i then wire ground to the right wiper or what would be called 'pot end'
using this terminology? or is it not needed?
With the individual frequency pots which wipers do i wire RE and RC to and
do i need to wire a ground to the remaining wiper?
Last question is there any problem using 5mm LED's over the 3mm ones? these
are the specs from the ones i want to use :
Reverse Voltage (VR) 5V
Reverse Current ( at VR=5V) <=10uA
Operating Temperature -40C ~ 85C
Storage Temperature -40C ~ 100C
Lead Soldering Temperature 260C for 5 seconds (Max)
Power Dissipation 4.5 mW
Emitted Color Blue
Wavelength (20mA) 465 - 475nm
Lens Appearance Water Clear
Absolute max Rating Pd : 120 mW
IF : 20 mA
Peak IF : 120 mA
Electro-optical Date (20mA) VF : 3.2V (Max 3.4V)
IV : 4,000 mcd (3,500 mcd Min, 4,500mcd Max)
Anyway thanks for the answers im sure will be forthcoming ;) can't wait to
get this baby powered ;) and if you wnat to reply direct email to
brett.maddaford@...
cya
Brett
just after some tips on the quper psycho, i've figured out all the wiring
etc in the most part but wanted to check what this means :
GC Glide pot center
GB Glide pot beginning
LC Level pot center
LB Level pot beginning
What is beginning? the left wiper when looking at the pot down the shaft or
from behind the pot....or something else?
Do i then wire ground to the right wiper or what would be called 'pot end'
using this terminology? or is it not needed?
With the individual frequency pots which wipers do i wire RE and RC to and
do i need to wire a ground to the remaining wiper?
Last question is there any problem using 5mm LED's over the 3mm ones? these
are the specs from the ones i want to use :
Reverse Voltage (VR) 5V
Reverse Current ( at VR=5V) <=10uA
Operating Temperature -40C ~ 85C
Storage Temperature -40C ~ 100C
Lead Soldering Temperature 260C for 5 seconds (Max)
Power Dissipation 4.5 mW
Emitted Color Blue
Wavelength (20mA) 465 - 475nm
Lens Appearance Water Clear
Absolute max Rating Pd : 120 mW
IF : 20 mA
Peak IF : 120 mA
Electro-optical Date (20mA) VF : 3.2V (Max 3.4V)
IV : 4,000 mcd (3,500 mcd Min, 4,500mcd Max)
Anyway thanks for the answers im sure will be forthcoming ;) can't wait to
get this baby powered ;) and if you wnat to reply direct email to
brett.maddaford@...
cya
Brett