Hi Guys
Alright Im not 100% sure on calibration on the Bi-N-Tic.
I set the Zero trim up based on the info on the VCO page, Frequency and Fine Tune pots in center division, adjust till there is 0 volts at Pin 7 of IC1. Alright that is finished.
Now the span trim is where I am unsure, VCO page says to feed 1v/Oct jack 1volt, which I have done, now adjust trim until output oscillator is one volt higher. Where is the oscillator out on the Bi-N-Tic, and is this correct so far.
Thanks
Chris
www.thealisonproject.com
[Non-text portions of this message have been removed]
Alright Im not 100% sure on calibration on the Bi-N-Tic.
I set the Zero trim up based on the info on the VCO page, Frequency and Fine Tune pots in center division, adjust till there is 0 volts at Pin 7 of IC1. Alright that is finished.
Now the span trim is where I am unsure, VCO page says to feed 1v/Oct jack 1volt, which I have done, now adjust trim until output oscillator is one volt higher. Where is the oscillator out on the Bi-N-Tic, and is this correct so far.
Thanks
Chris
www.thealisonproject.com
[Non-text portions of this message have been removed]