Yahoo Groups archive

Cgs synth

Index last updated: 2026-04-28 23:16 UTC

Thread

Bi-N-Tic, Trim Help

Bi-N-Tic, Trim Help

2006-12-01 by The Alison Project

Hi Guys

Alright Im not 100% sure on calibration on the Bi-N-Tic.

I set the Zero trim up based on the info on the VCO page, Frequency and Fine Tune pots in center division, adjust till there is 0 volts at Pin 7 of IC1. Alright that is finished.

Now the span trim is where I am unsure, VCO page says to feed 1v/Oct jack 1volt, which I have done, now adjust trim until output oscillator is one volt higher. Where is the oscillator out on the Bi-N-Tic, and is this correct so far.

Thanks
Chris

www.thealisonproject.com



[Non-text portions of this message have been removed]

Re: Bi-N-Tic, Trim Help

2006-12-01 by sasami@hotkey.net.au

>Now the span trim is where I am unsure, VCO page says to feed 1v/Oct jack
1volt, which I have done, now adjust trim until output oscillator is one
volt higher.

1 octave higher, not one volt.

>Where is the oscillator out on the Bi-N-Tic, and is this correct so far.

The pad you want is marked CLKO. Its near pin 8 of IC4


Ken
_______________________________________________________________________
Ken Stone sasami@...
Modular Synth PCBs for sale <http://www.blaze.net.au/~sasami/synth/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>

Re: Bi-N-Tic, Trim Help

2006-12-02 by The Alison Project

Thank you, got it done...

Just have to say this list is amazingly helpful. I have recently finished a bunch of projects that up till recently I wasnt sure I could handle, with everyone's help the modular grows.

chris

www.thealisonproject.com
----- Original Message -----
Show quoted textHide quoted text
From: sasami@...
To: cgs_synth@yahoogroups.com
Sent: Thursday, November 30, 2006 11:24 PM
Subject: Re: [cgs_synth] Bi-N-Tic, Trim Help


>Now the span trim is where I am unsure, VCO page says to feed 1v/Oct jack
1volt, which I have done, now adjust trim until output oscillator is one
volt higher.

1 octave higher, not one volt.

>Where is the oscillator out on the Bi-N-Tic, and is this correct so far.

The pad you want is marked CLKO. Its near pin 8 of IC4

Ken
__________________________________________________________
Ken Stone sasami@...
Modular Synth PCBs for sale <http://www.blaze.net.au/~sasami/synth/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>





[Non-text portions of this message have been removed]

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.