Hi,
I recently received Kens ring modulator board. While it works/sounds
fine, I noticed that I have some bass frequency loss. Even when using
a very low carrier frequency, say 10 Hz or lower (ie essentially
amplitude modulation) it is clearly audible compared to the dry
signal. Now I'm very new to this. I'm using a case with 3 mono jacks
attached to it and 6 small wires to connect them to the board. My
question is, is a minor bass frequency loss normal in passive ring
modulators? If not, how can I determine the cause?
Best Regards,
Richard
I recently received Kens ring modulator board. While it works/sounds
fine, I noticed that I have some bass frequency loss. Even when using
a very low carrier frequency, say 10 Hz or lower (ie essentially
amplitude modulation) it is clearly audible compared to the dry
signal. Now I'm very new to this. I'm using a case with 3 mono jacks
attached to it and 6 small wires to connect them to the board. My
question is, is a minor bass frequency loss normal in passive ring
modulators? If not, how can I determine the cause?
Best Regards,
Richard