Hi
I've built a green REV 1.1 board, and plan to include a DPDT toggle to
switch between dirty and clean.
As per the info on the CGS site, either the 330K resistor and solid
line link *OR* 330K in the unlabelled slot and the broken line are
connected.
( someone posted here a while back that they'd had success with a
switch....)
Question is, do pins 1 + 2 of the 1SH24b need to be swapped too?. At
the moment, they're connected to the additional "swapped" pin 1 and 2
holes provided on the rev 1.1 pcb.
Will the tube come to any harm if they're left there, whilst the other
connections are switched?
cheers,
Dave
I've built a green REV 1.1 board, and plan to include a DPDT toggle to
switch between dirty and clean.
As per the info on the CGS site, either the 330K resistor and solid
line link *OR* 330K in the unlabelled slot and the broken line are
connected.
( someone posted here a while back that they'd had success with a
switch....)
Question is, do pins 1 + 2 of the 1SH24b need to be swapped too?. At
the moment, they're connected to the additional "swapped" pin 1 and 2
holes provided on the rev 1.1 pcb.
Will the tube come to any harm if they're left there, whilst the other
connections are switched?
cheers,
Dave