Cgs synth

>the parts list on ken's page calls out 2x 100n caps as being used, yet i

only see a few 10uf

>electrolitics and 22n's noted on my pcb board. there is no more room for

caps on here, so

>what were those called out for??

The positions for the two 100n caps are near the lower chip, to its left,
when the pots are to the right of the PCB. They are power rail decoupling.

>also, i am assuming that since i was not setting this up for using the "cx"

cap, i just leave that empty

Correct. You will notice it has a short on the back of the PCB. You would
need to cut the track if you were to install CX. It's just an option.

... and i also assume that i am supposed to add a jumper where it appears to be

>indicated with 3 boxed symbols next to the beads/elec caps on the lower

left side of the

>pcb.

There is a single jumper just below the unicorn's head.
The three "boxed" pads in the lower left are for when stacking PCBS
together, and can safely be ignored.

You do have some sort of construction error, or less likely, a part failure.
Resonance definitely works.

Ken
_______________________________________________________________________
Ken Stone sasami@...
Modular Synth PCBs for sale <http://www.cgs.synth.net/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>