I'm having problems with mine. :( The LEDs barely light up, and only
the first one does. I could use some help with the step switch too.
Maybe I'll disconnect it for a while.
I've been concentrating on my cabinet lately, but now I'll have a
little time to work on the sequencer again. Maybe you can explain how
it's all supposed to be wired up, and if I need any diodes to make the
connections one-way.
I haven't wired up the glide yet. Right now I'm just trying to get the
lights to go 1-8 and back again.
the first one does. I could use some help with the step switch too.
Maybe I'll disconnect it for a while.
I've been concentrating on my cabinet lately, but now I'll have a
little time to work on the sequencer again. Maybe you can explain how
it's all supposed to be wired up, and if I need any diodes to make the
connections one-way.
I haven't wired up the glide yet. Right now I'm just trying to get the
lights to go 1-8 and back again.
> On Jun 7, 2008, at 10:16 AM, Scott Deyo wrote:[Non-text portions of this message have been removed]
>
>> hey all,
>>
>> so i finished my sequential switch/ event sequencer this morning. it
>> roolz, all other seq's droolz!
>> ; )
>>
>> the up/down control, the reset and inhibit controls, inverted output,
>> mix input -- what a great module!
>> adding LFOs to certain steps makes it very very very fun, or even
>> audio
>> -- get some FM klang on every fifth step, for example.
>>
>> i added a gate bus jack for the switches, w/ a diode between each
>> gate
>> output and switch, all switches' middle lugs bussed to the jack --
>> works great, but i used four different-colored LEDs, and not all
>> gates
>> are at the same level (very close though). i'll take the tradeoff for
>> prettiness.
>>
>> the bridechamber glide DOES NOT WORK when inserted before the mixer
>> output. the 4051 must be sendin' somethin' the glide doesn't like. i
>> think the 358 locked up, which was weird. maybe it was the 4051,
>> though; i didn't test it. so i put the glide after the circuit's
>> outputs, using a dual-gang pot for glide.
>>
>> the audio-rate glide works well at audio-rate clocking. now if only
>> we
>> had an ultra-sonic VCO... maybe just maybe someone will be coming out
>> w/ one pretty darn soon (hint hint)...
>>
>> my step selection rotary is a little weird, though. some steps are
>> skipped, though i've checked my wiring 10 times...
>>
>> i love this module. there is a forest of wire back there, so put on
>> some good tunes and relax; it'll take a while.
>>
>> i'll be adding final pics to the site today or tomorrow, and some
>> sound
>> samples too.
>>
>> cheers,
>> Scott Deyo
>> The Bridechamber
>> contact@...
>> http://www.bridechamber.com
>> Jealous Edison Record Kompany
>> http://www.jealousedison.com
>>
>