A little jumper from two pads further up the same traces will be fine.
Alternately, scrape the green solder mask off the tracks, and tack a thing
strand of wire across that way.
Ken
Ken Stone sasami@...
Modular Synth PCBs for sale <http://www.blaze.net.au/~sasami/synth/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>
Alternately, scrape the green solder mask off the tracks, and tack a thing
strand of wire across that way.
Ken
>Hello all,_______________________________________________________________________
>
>I've put 90% of the CGS Steiner VCF PCB together. While trying to
>dance with its alleged input-capacitor capers, I still soldered one
>in incorrectly. During the removal of said cap (the HP input 1uF,
>where I'm going to place a link.), I sucked up the two little round
>metallic 'joints' on the PCB where the cap was, leaving a 'gap' in a
>couple of the PCB traces.
>I tried to lay a little solder in the holes but it won't stick. I'm
>guessing I'll have to use some wire jumpers to complete the traces in
>a rough 'point to point' fashion.
>
>Any advice?
>
>This is my first PCB population attempt and I'm sure this will happen
>to me again.
>
>Next up, the CGS WaveMultiplier!
>
>Thanks and Best Regards,
>Chris
>
>
>
>See the following URLS for the CGS Modular Synth home page:
>Main: http://www.cgs.synth.net/
>Secondary: http://otherunicorn.0catch.com/synth/
>To unsubscribe from this group, send an email to:
>cgs_synth-unsubscribe@yahoogroups.com
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
Ken Stone sasami@...
Modular Synth PCBs for sale <http://www.blaze.net.au/~sasami/synth/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>