I'm getting ready to build the sequential switch and need advice on a
few things.
First off, what would be the best way to incorporate pots at the
inputs? What pot values would work best & what's the best way to wire
each pot into the switch?
Second, would it make sense to build the switch so that one had the
option of routing in external signals to each of the inputs? If so,
would it be possible to use the pots to set CV's if no jack was
inserted, but adjust the input level when a jack was inserted?
What's the Inhibit input do?
Also, I haven't seen a panel for this - I'll try to put one together.
Here are the panel items I've identified:
Inputs:
Reset - Momentary Switch
Reset In - jack
Up/Down - Toggle
Clock In - jack
Inhibit - jack
Mix In - jack
In 1-8 - jacks
Levels 1-8 - pots
Output Jacks:
Out
Inverted Out
Gate 1-8
Flashy Lights
Gate 1-8
Any comments or suggestions on this?
Thanks in advance for the help!
few things.
First off, what would be the best way to incorporate pots at the
inputs? What pot values would work best & what's the best way to wire
each pot into the switch?
Second, would it make sense to build the switch so that one had the
option of routing in external signals to each of the inputs? If so,
would it be possible to use the pots to set CV's if no jack was
inserted, but adjust the input level when a jack was inserted?
What's the Inhibit input do?
Also, I haven't seen a panel for this - I'll try to put one together.
Here are the panel items I've identified:
Inputs:
Reset - Momentary Switch
Reset In - jack
Up/Down - Toggle
Clock In - jack
Inhibit - jack
Mix In - jack
In 1-8 - jacks
Levels 1-8 - pots
Output Jacks:
Out
Inverted Out
Gate 1-8
Flashy Lights
Gate 1-8
Any comments or suggestions on this?
Thanks in advance for the help!