--- In cgs_synth@yahoogroups.com, cgs_synth@yahoogroups.com wrote:
This looks good overall.
The only thing I'm not sure about is whether it would make sense to
somehow line up the stage knobs with the stage in's, gates & led's.
That's what they did with the UEG, which is similar in some ways:
http://www.encoreelectronics.com/cont_ueg1.html
To get everything lined up and still keep the pots with MOTM spacing
would eat up a lot of panel space, though.
I have a question - how does the Up/down jack wire in? This is how
I'm reading it:
UD switch - Top to +15, middle to SW pad, bottom to NC connector or
UD jack.
UD jack then would have the signal connector wired to UD pad.
Is that right?
Also - what the RSS pad on the pcb for?
Thanks!
> Description : a draft for a motmized sequential switch panel -comments welcome (leds are not lined up yet right)
This looks good overall.
The only thing I'm not sure about is whether it would make sense to
somehow line up the stage knobs with the stage in's, gates & led's.
That's what they did with the UEG, which is similar in some ways:
http://www.encoreelectronics.com/cont_ueg1.html
To get everything lined up and still keep the pots with MOTM spacing
would eat up a lot of panel space, though.
I have a question - how does the Up/down jack wire in? This is how
I'm reading it:
UD switch - Top to +15, middle to SW pad, bottom to NC connector or
UD jack.
UD jack then would have the signal connector wired to UD pad.
Is that right?
Also - what the RSS pad on the pcb for?
Thanks!