Thanks again Ken
________________________________
From: "sasami@..." <sasami@...>
To: cgs_synth@yahoogroups.com
Sent: Wednesday, January 25, 2012 9:25 PM
Subject: Re: [cgs_synth] Stacking PCB's and Power bussing.
would go...).
You mean the beads? Yes, and yes.
Ken
__________________________________________________________
Ken Stone sasami@... otherunicorn@...
Modular Synth PCBs for sale <http://www.cgs.synth.net/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>
[Non-text portions of this message have been removed]
________________________________
From: "sasami@..." <sasami@...>
To: cgs_synth@yahoogroups.com
Sent: Wednesday, January 25, 2012 9:25 PM
Subject: Re: [cgs_synth] Stacking PCB's and Power bussing.
>My question is about power bussing between the two.one board to the corresponding pad of the board below (where the connector
>
>Firstly , can i just run a wire soldered to the bottom of the connector of
would go...).
>Yes.
>ie : + to + , etc.
>Also , does the board below need the two 10uF electro's and buffersinstalled if the power is getting to them that way ?
You mean the beads? Yes, and yes.
Ken
__________________________________________________________
Ken Stone sasami@... otherunicorn@...
Modular Synth PCBs for sale <http://www.cgs.synth.net/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>
[Non-text portions of this message have been removed]