Thank you much for the info...
Best,
Gary
________________________________
From: emmaker <jays@...>
To: cgs_synth@yahoogroups.com
Sent: Sunday, April 8, 2012 10:34 AM
Subject: [cgs_synth] Re: aluminum panels
Gary,
You might start with looking at the forums for Muff Wigglers:
http://www.muffwiggler.com/forum/
There are a lot of panels that people do and make available.
You might also check Front Panel Express out which a lot of DIYs use:
http://www.frontpanelexpress.com/
You can have a panel cut to size and drilled. Then you can supply the graphics. Or you can use their labeling/engraving. Not cheap though.
Jay S.
Best,
Gary
________________________________
From: emmaker <jays@...>
To: cgs_synth@yahoogroups.com
Sent: Sunday, April 8, 2012 10:34 AM
Subject: [cgs_synth] Re: aluminum panels
Gary,
You might start with looking at the forums for Muff Wigglers:
http://www.muffwiggler.com/forum/
There are a lot of panels that people do and make available.
You might also check Front Panel Express out which a lot of DIYs use:
http://www.frontpanelexpress.com/
You can have a panel cut to size and drilled. Then you can supply the graphics. Or you can use their labeling/engraving. Not cheap though.
Jay S.
--- In cgs_synth@yahoogroups.com, "Gary" <hydrophilos@...> wrote:
>
> Does anyone know where the aluminum panel/plate with holes (serge style) can be obtained for mounting the pots switches etc.?
>
> Thanks,
> Gary
>
[Non-text portions of this message have been removed]