Cgs synth

If I understand you, yes. You are putting the trimmer in series with the
existing resistor. Only two connections to the trimmer are needed.
Ken

>Would i wire it : resistor > outer leg of trimmer > trimmer wiper to

remaining resistor pad > leave other side (outer) trimmer leg unconnected ?

>
>
>________________________________
> From: "sasami@..." <sasami@...>
>To: cgs_synth@yahoogroups.com
>Sent: Saturday, May 26, 2012 4:13 PM
>Subject: Re: [cgs_synth] CGS 114 - Improving 1V/ Oct tracking on DUSG.
>
>
>Â
>Yes, the 1k5 resistor connected to the 82k connected to pad E is the correct
>resistor to be messing around with.
>Ken
>
>>Hi Ken
>>
>>It's TCB day on the BOCGS panel...
>>
>>I was about to do the mod mentioned here :
>>
>>http://www.muffwiggler.com/forum/viewtopic.php?p=495151&amp;highlight=#
>495151
>>
>>
>>For improving 1V/ Oct tracking.
>>
>>
>>When i looked at the schematic and then the PCB overlay it seems the 1.8K
>in the schematic is marked as a 1.5K on the overlay.
>>
>>http://www.cgs.synth.net/modules/pic/pcb_cgs114_dusg.gif
>>
>>
>>Am i right in assuming the 1.5K is the one i'm changing out if i'm going
>ahead with this mod ?
>__________________________________________________________
>Ken Stone sasami@... otherunicorn@...
>Modular Synth PCBs for sale <http://www.cgs.synth.net/>
>Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>
>
>
>
>
>[Non-text portions of this message have been removed]
>
>
>
>------------------------------------
>
>The CGS Modular Synth home page: http://www.cgs.synth.net/
>Yahoo! Groups Links
>
>
>
>

_______________________________________________________________________
Ken Stone sasami@... otherunicorn@...
Modular Synth PCBs for sale <http://www.cgs.synth.net/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>