Cgs synth

Soldering them to the resistor leads sounds like a plan. That should give
you some structural support as well as a good connection.

Ken

>Hi Ken
>
>I finally got a hold of the 1uF BP electros for the CGS113 and it turns out

the pins are too wide to fit through the PCB !!

>
>I measured the pins width at 0.8mm. I have a 1mm drillbit but am a bit

worried about damaging the PCB traces , as i only have a handheld drill ; no
drill press.

>
>The other alternative i thought of is to just solder the 1uF BP caps

directly to the resistors next to the them (the next thing along on the
traces...)

>
>Which would you recommend ?
>
>[Non-text portions of this message have been removed]
>
>
>
>------------------------------------
>
>The CGS Modular Synth home page: http://www.cgs.synth.net/
>Yahoo! Groups Links
>
>
>
>

_______________________________________________________________________
Ken Stone sasami@... otherunicorn@...
Modular Synth PCBs for sale <http://www.cgs.synth.net/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>