Hi all,
I'm wiring up a DUSG PCB to my panel and following Ken's instructions on his site.
Please correct if I'm wrong but:
MB on the schematic is RISE
MA on the schematic is FALL
the Wiring table on the same page lists them the other way around. Which to follow?
Also:
DCO is MAIN OUT
D goes to BIPOLAR OUT
What is BPO (AC COUPLED OUT)?
Lastly, I've seen some pics of builds where F and FC are not connected. such as:
https://www.muffwiggler.com/forum/userpix2/10087_quad_slope_02_1.jpg
Does that look right and if so, how? Or again should I just follow the wiring table?
Its my first CGS Board, sorry if this is obvious or previously covered somewhere.
Thanks!