Yahoo Groups archive

Cgs synth

Index last updated: 2026-04-28 23:16 UTC

Thread

CGS48 VCO calibration

CGS48 VCO calibration

2013-01-26 by Steve Inselman

Hello
To adjust the Span trimmer what output should I connect to for calibrating the voltage?
I tried the waveforms but the span trimmer had no effect on the voltage. I also tried the other 1v/oct but it is connected to initial freq wiper.
Thanks,
Steve


[Non-text portions of this message have been removed]

Re: CGS48 VCO calibration

2013-01-26 by Stephen Richards

There are instructions for calibrating the VCO here :

http://www.cgs.synth.net/modules/cgs48_vco.html


The second paragraph deals with Span trimmer calibration.


________________________________
Show quoted textHide quoted text
From: Steve Inselman <steveinselman@...>
To: CGS <cgs_synth@yahoogroups.com>
Sent: Sunday, January 27, 2013 8:07 AM
Subject: [cgs_synth] CGS48 VCO calibration



Hello
To adjust the Span trimmer what output should I connect to for calibrating the voltage?
I tried the waveforms but the span trimmer had no effect on the voltage. I also tried the other 1v/oct but it is connected to initial freq wiper.
Thanks,
Steve

[Non-text portions of this message have been removed]




[Non-text portions of this message have been removed]

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.