Datacolor User to User Support Group.

I had the same problem. Did everything you did then
about 4 hours later it finally (no known reason) would
calibrate the Spectrocolor meter and read my prints.

Has it been 4 hours? Good luck!  Dave

--- bill_hansen20012001 <b2hansen@...> wrote:

> Win XP Pro with all service packs and updates.
> 
> This may be a re-post. I tried sending this message
> to the group 
> severalminutes ago but it obviously didn't make it
> onto the board.
> 
> Two days ago I printed out targets for two papers
> and let them dry 
> overnight, then make a profile for one of the
> targets today. That 
> went fine - just needed to increase Brightness by +2
> to get an 
> essentially "perfect" profile.
> 
> But when I try to read patches of the second
> printout, I find that 
> (1)the "save measurements to" choice is grayed out,
> (2) the only 
> available choice is "select an existing measurement
> file", which 
> shows the file created for my first profile, and
> (3)I can't access 
> the "calibrate" function from the Tools dropdown.
> 
> I've tried shutting down PFP and opening it up
> again. I've tried re-
> booting the computer. Neither helps. I don't see a
> solution in the 
> Help files. From reading this e-list, I have the
> impression that 
> uninstalling version 1.1.1 won't help either.
> 
> Is there a simple solution? Am I missing something
> dead obvious 
> here? Any suggestions appreciated. I'm dead in the
> water as far as 
> creating profiles is concerned.
> 
> Bill Hansen
> 
> 
> 
> 
>