___I notice that my monitor shows a little "blip" every minute. I assume that is because the Spyder3 v 3.06 Utility preference has a setting "Load Video Card Lookup Table Every: it is set to 1 minute. I assume that is that is the default setting. Is it necessary to load the LUT that often. The screen "disturbance" I see is a bit disconcerting. I suppose I will get accustomed to it, now that I know (or think I know) what is causing it.
This indicates, not just that Spyder3Utility is checking the LUT, but if it blips every minute, it would also imply that your LUT is not probably correct, or you would not be seeing the blip. So, as well as adjusting the timing, look into what might be conflicting with the Datacolor LUT loading...
-----Original Message-----
From: madigan_bill
To: colorvision_group@yahoogroups.com
Sent: Sun, 14 Dec 2008 3:57 pm
Subject: [colorvision_group] How often does the Utility need to load the VIdeo Card LUT?
C. David Tobie
WW Product Technology Manager
Digital Imaging & Home Theater
Datacolor
CDTobie@...
www.datacolor.com/Spyder3
www.colorvision.com
WW Product Technology Manager
Digital Imaging & Home Theater
Datacolor
CDTobie@...
www.datacolor.com/Spyder3
www.colorvision.com
-----Original Message-----
From: madigan_bill
To: colorvision_group@yahoogroups.com
Sent: Sun, 14 Dec 2008 3:57 pm
Subject: [colorvision_group] How often does the Utility need to load the VIdeo Card LUT?
I notice that my monitor shows a little "blip" every minute. I assume
that is because the Spyder3 v 3.06 Utility preference has a
setting "Load Video Card Lookup Table Every: it is set to 1 minute. I
assume that is that is the default setting. Is it necessary to load the
LUT that often. The screen "disturbance" I see is a bit disconcerting.
I suppose I will get accustomed to it, now that I know (or think I
know) what is causing it.
I asked tech support the following question but did not receive an
answer.
Is Cerification necessary with the new verson 3.06 Utility? Under the
Certification preference tab, the certification is checking every hour.
I believe Certification checks to make sure the LUT is being loaded.
Since the LUT is being reloaded every minute, does Certification just
verify that it is being loaded? I added Certificaton when I calibrated
so I would know that the LUT was loaded - did not know how to verify
that with version 3.04. on Vista 64
Is their a document describing the preference settings in the Utility?
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/colorvision_group/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/colorvision_group/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:colorvision_group-digest@yahoogroups.com
mailto:colorvision_group-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
colorvision_group-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/