Datacolor User to User Support Group.

1.What do you mean by your that my "LUT is not probably correct"? 
2.What timing should I adjust?
3. Telling me that I should "look into what might be conflicting with 
the Datacolor LUT loading" is not real helpful. What makes you think 
soething is conflicting? This is a fairly clean install of Vista 64. 
What do you suggest I should be looking for? I have wasted hours and 
hours attempting to figure this out. 

...
--- In colorvision_group@yahoogroups.com, CDTobie <CDTobie@...> wrote:
>
> 
> 
> 
> I notice that my monitor shows a little "blip" every minute. I 
assume 
> that is because the Spyder3 v 3.06 Utility preference has a 
> setting "Load Video Card Lookup Table Every: it is set to 1 minute. 
I 
> assume that is that is the default setting. Is it necessary to load 
the 
> LUT that often. The screen "disturbance" I see is a bit 
disconcerting. 
> I suppose I will get accustomed to it, now that I know (or think I 
> know) what is causing it.
> 
> ___
> This indicates, not just that Spyder3Utility is checking the LUT, 
but if it blips every minute, it would also imply that your LUT is 
not probably correct, or you would not be seeing the blip. So, as 
well as adjusting the timing, look into what might be conflicting 
with the Datacolor LUT loading...
> 
> 
> C. David Tobie
> WW Product Technology Manager
> Digital Imaging & Home Theater
> Datacolor
> CDTobie@...
> www.datacolor.com/Spyder3
> 
> www.colorvision.com
> 
> 
> -----Original Message-----
> From: madigan_bill <madigan_bill@...>
> To: colorvision_group@yahoogroups.com
> Sent: Sun, 14 Dec 2008 3:57 pm
> Subject: [colorvision_group] How often does the Utility need to 
load the VIdeo Card LUT?
> 
> 
> 
> 
> 
> 
> 
> 
> I notice that my monitor shows a little "blip" every minute. I 
assume 
> that is because the Spyder3 v 3.06 Utility preference has a 
> setting "Load Video Card Lookup Table Every: it is set to 1 minute. 
I 
> assume that is that is the default setting. Is it necessary to load 
the 
> LUT that often. The screen "disturbance" I see is a bit 
disconcerting. 
> I suppose I will get accustomed to it, now that I know (or think I 
> know) what is causing it.
> 
> I asked tech support the following question but did not receive an 
> answer.
> 
> Is Cerification necessary with the new verson 3.06 Utility? Under 
the 
> Certification preference tab, the certification is checking every 
hour. 
> I believe Certification checks to make sure the LUT is being 
loaded. 
> Since the LUT is being reloaded every minute, does Certification 
just 
> verify that it is being loaded? I added Certificaton when I 
calibrated 
> so I would know that the LUT was loaded - did not know how to 
verify 
> that with version 3.04. on Vista 64
> 
> Is their a document describing the preference settings in the 
Utility? 
> 
> 
> ------------------------------------
> 
> Yahoo! Groups Links
>