Datacolor User to User Support Group.

I want to profile a Mitsubishi dye-sub that can only print up to 9"x6". 
I know I can resize the target in the print driver to fit on the paper, 
but will the Spyder 3 be able to read from the smaller targets?

Thanks for your help. I was holding off on purchase until I could 
find this out. 

Vincent


 --- In colorvision_group@yahoogroups.com, CDTobie@... wrote:
>
> 
> In a message dated 5/1/08 10:31:06 AM, macphoto@... writes:
> 
> 
> > I want to profile a Mitsubishi dye-sub that can only print up to 
9"x6".
> > I know I can resize the target in the print driver to fit on the 
paper,
> > but will the Spyder 3 be able to read from the smaller targets?
> > 
> > 
> 
> There are special targets in the target folder for smaller 
printers. These 
> targets cut the 225 patch target into quaters, to fit printers as 
small as 4x5. 
> You can print them on your dyesub, tape the four together to 
recreate the 225 
> patch target, and read as you would any 225 patch target print. You 
will need 
> to print the targets from Photoshop, with care not to convert the 
colors in 

> the process, other than that it should be quite straightforward.
> 
> C. David Tobie
> WW Product Technology Manager
> Digital Imaging & Home Theater
> Datacolor
> CDTobie@...
> www.datacolor.com/Spyder3
> 
> 
> **************
> Need a new ride? Check out the largest 
> site for U.S. used car listings at AOL Autos.
>       
> (http://autos.aol.com/used?NCID=aolcmp00300000002851)
>