Message
Re: [disklavier] prc-100 no wireless card inserted
2014-01-03 by Adrian Thomas
Adrian Thomas
On Jan 3 2014, Bill Brandom wrote:
>STEVEN and JASON,
>
>Lets see if we can get your PRC-100 connected to your piano. Follow my
>instructions carefully. Hopefully, at the end of the process your remote
>will be connected to your Disklavier.
>
>PHASE 1:
>- First thing, power down the piano.
>
>- Press the STOP button on your PRC-100. The PRC-100 will go to sleep.
>
>- Turn the remote over. You are going to remove the battery. To do so,
>slide the slide switch from Normal Operation to Replace battery. Remove
>cover.
>
>- Remove battery
>
>- Look for RESET and the arrow pointing to a square hole.
>
>- With your stylus, put it in the square hole and lightly push in. You will
>feel a little button get pressed when you do this. Your PRC-100 is now
>reset.
>
>- Reinstall the battery. Replace battery cover, and switch the slide switch
>to Normal Operation.
>
>- Power up the piano.
>
>- Press the STOP button on the PRC-100 to wake it up. Wake up will take 2
>minutes.
>
>- PRC-100 should now connect to Disklavier. If not, perform PHASE 2.
>
>
>PHASE 2:
>- Tap on the MENU icon at the bottom of the PRC-100 screen.
>
>- Tap on NETWORK
>
>- The screen will now display NAME with a DKV****** I.D. below it or
>TEMPORARY xxxx below it. Tap on DELETE. Then tap on YES, then tap on X in
>the upper right corner of the PRC100.
>
>- Get under the piano and hold your PRC-100 close to the I/O center (the
>largest box under the piano). Then tap on PIANO ASSIGN, then tap on OK.
>Keep the PRC-100 close to the I/O center. Hopefully, it will connect to the
>piano. If so, a DKV******* piano ID will be displayed on the PRC-100. If
>so, you are connected.
>
>Let me know the results. If we get you connected, then we can discuss the
>other issues you have raised.
>
>Bill
>
>
>On Thu, Jan 2, 2014 at 3:35 PM, wrote:
>
>>
>>
>> i have a disklavier mark iv and the prc-100 will not connect to the mark
>> iv. controller still has interface, no connect. it is running version 2 of
>> the software and would like to upgrade. i was told i have to upgrade to 3
>> then thru an internet connection i can upgrade to 4. problem is the mark iv
>> is not on line, is the prc-100 the only way to get the mark iv on line.
>> second question is can i up grade the software on the mark iv with out it
>> being online, and does the upgraded software give me any more control over
>> getting the mark iv online with out a prc-100. lastly, do you know where i
>> could rent a prc-100 for an hour
>>
>>
>