Disklavier

Similarly on the PC, Netstumbler can be  used to analyze WiFi channel strength.

Fred
Freehold NJ





On Saturday, January 25, 2014 9:40 AM, "ken@..." <ken@...> wrote:
 
  
I would be more than happy to help you.  I am very good working with the Mark IV and know it a little better than I should. Plus, I'm also very good at troubleshooting network issues. I found that earlier software upgrades versions changed some defaults settings that make it harder to connect.  I'll walk you through but it might be best over the phone.  I'm retired and I'm at my home from an extended trip.

Email me your telephone number.

You could try to call me, but until I enter your phone number in my phone's address book, my phone won't ring! I get an extreme number of telemarketers or wrong number hang ups daily. - so if I'm not looking at my phone the moment you call I most likely will not answer. You must to leave a message longer than 6 seconds and I can call you back. 

Ken Ruda
816-210-1010 mobile

Ken@...


---In disklavier@yahoogroups.com, <jasonrglover@...> wrote:


New friends,

I have a DKV Mark IV, and I am moderately tech savvy, but I just can't reconnect the PRC to the DKV. I recently installed an ethernet port next to the piano (Dec 31) and the piano worked as of Dec 31, but after rebooting (the manual said to reboot before installing the ethernet cable), it refuses to connect to the PRC-100. 


I have carefully perused and applied most of the fixes to this topic, and I am checking to see if there is something more I can do:


My PRC-100 comes on, and works, but can't find the dkv wireless lan. Even when it is inches away.

However, i can see the DKV network broadcasting from my ipad (as athomik and kevin g have suggested, to be sure the I/O wireless is broadcasting).

I have applied Carol's patient rebooting process as well, including a "30 min off time" for the DKV, as I once read in the manual.

I have turned off a nearby WAP (wireless access point).

One tidbit, I am using very very old software...i havent' upgraded in at least 6yrs. It sounds like the only path to an upgrade is via a cd-rom...which Yamaha support is sending me(open to other suggestions). I'm not convinced the upgrade will work, since the PRC-100 has to be assigned to the DKV in the first place. 

Can anyone lend any help? One post suggested using "dkvbrowser" on a pc to force the pc to be the controller - how can i find this?

Any previous folks with problems get theirs solved (GregB post was very similar to my issue)...?

Thanks in advance,

Jason