Yahoo Groups archive

Disklavier

Index last updated: 2026-04-28 23:20 UTC

Message

Re: [disklavier] Service Manual and Schematics for MarkII DKC100R

2014-12-30 by Brad Harper

Carol,

A little more background.  This problem has gotten worse over the last 10 
Months.  When the problem first started, the piano would play for about 40 
Minutes, before the problem occurred.  I could actually play an entire 
Pianosoft diskette before it started happening.  Around this time, I also 
upgraded the firmware in the DKC100R controller, because it would not read 
IBM formatted diskettes.  The firmware fixed that problem, after a couple 
tries(bad firmware on the shelf).  I started using the system more because 
I could buy titles that I could download from Yamaha and play.  My system 
has the MU50 sound module as well.  The problem slowly got worse, with 
shorter and shorter play times, before the error occurred. Now the system 
will fault at the first song on a disk.

I took the cover off the foot pedal solenoid mechanism, and disconnected 
the solenoids, but same issue.  Watching the solenoids, it seems like the 
power to them is weak, as the sustain solenoid, only actuated about half 
of it’s travel.  I disconnected the linkages, and it would travel the 
whole distance.  Still no help, about 30 seconds of song play.  

I truly think the power supply is not working up to capacity, and then 
causing the shutdown.  That is why I am looking for a schematic, and 
service manual, so I can test it, and see if it needs to be reworked.

The power supply is not an in-expensive item, and I don’t want to replace 
it, unless I know it is the cause of the problem.  Also I would much 
rather fix than replace.  I have a background in electronics, so I have no 
problem tackling the repair, but I prefer to not do it blindly.  A 
schematic, with test voltages, and testing points, as well as a history of 
common failures would be of great assistance.  Since I retired, I watch 
how I spend a lot more carefully.  I don’t want to just parts swap for the 
purpose of troubleshooting.  I want to make sure that what I buy will 
solve the problem.

Brad 

From:  "Brad Harper bharper33@... [disklavier]" 
<disklavier@yahoogroups.com>
Reply-To:  <disklavier@yahoogroups.com>
Date:  Tuesday, December 30, 2014 at 11:54 AM
To:  <disklavier@yahoogroups.com>
Subject:  Re: [disklavier] Service Manual and Schematics for MarkII DKC100R

 
 
 
 
   

Thanks Carol,

Could this have been caused by moving the piano to a new location?  I did 
not have this problem until the piano was moved.  It was in storage for 
about 6 months.

This link does not contain a Service manual though, is there still one 
more manual?

Thanks again… Brad
From:  "Carol Beigel carol@carolrpt.com [disklavier]" 
<disklavier@yahoogroups.com>
Reply-To:  <disklavier@yahoogroups.com>
Date:  Tuesday, December 30, 2014 at 10:46 AM
To:  <disklavier@yahoogroups.com>
Subject:  Re: [disklavier] Service Manual and Schematics for MarkII DKC100R

 
  
   

This could be a damper pedal solenoid out of adjustment.  When it  heats 
up it shuts down the entire system.  If it was a power supply it probably 
would not start to play at all.  An experienced Disklavier tech is best 
equipped to make this adjustment.  Otherwise you will find it in the 
service manual or the maintenance manual instructions how to do this.


Carol Beigel

On Dec 30, 2014, at 8:15 AM, 'MixMeisterBob' mixmeisterbob@... 
[disklavier] <disklavier@yahoogroups.com> wrote:



http://yamahaden.com/resources-2/item/281-mark-ii-manual
 
From: disklavier@yahoogroups.com [mailto:disklavier@yahoogroups.com] 
Sent: Tuesday, December 30, 2014 2:36 AM
To: disklavier@yahoogroups.com
Subject: [disklavier] Service Manual and Schematics for MarkII DKC100R
 
  
Hi All,
 
I am looking for a Service Manual and Schematics for MarkII DKC100R
 
I am Having a “PWM over” error, shortly after starting playback, so I am 
looking for a Service Manual with Schematics for the Solenoid Power 
supply, and any good advice on tests, and what to look for.
 
That’s a good starter discussion.
 
Thanks for your Help… Brad
Brad Harper
Bharper33@...

Attachments

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.