Disklavier

In a nutshell,

- create the boot floppy in the Disklavier.

- put both the CD and floppy into their drives, then power down the piano by holding in the green oblong button until it starts blinking.

- when it is off, power it back up. The loading phase of the update will start. This may take 20 minutes. Different LEDs will blink during the process. Then the CD tray will open.

- Remove the CD and close the tray. About 30 seconds later the piano will go completely off. 

- power it up again. The update installation will take another 20 minutes. It will be done when the oblong green(LED) button is either bright or dull green, with no other LEDs blinking.

Let me know if this works for you. If so, then I will explain how to update the PRC100 remote.

Bill
Love God. Love People. Make a difference.


On May 21, 2016, at 6:39 PM, dmitryos@... [disklavier] <disklavier@yahoogroups.com> wrote:

Thank you so much, Bill!!

I'm really new t this and I just burnt a cd disk. Just to confirm: I need to make an installation FD disk and use it somehow to boot(?) the device with the cd inserted for the updated to start?
Appreciate the answer,
Dmitry