Emax

You are putting this through a phono pre-amp first, right?
because otherwise the turntable signal output (unless it is a newer table
with a line level out) would be way too low...


On Fri, Dec 30, 2011 at 11:20 AM, jdchevallier <joel.chevallier@...>wrote:

> **
>
>
> Still trying to get my emax to sample!
>
> I'd been having problems with the machine not getting an input signal (or
> a very weak one.) Before shipping it off for repair I pulled each of the
> chips inside, dusted the board and reseated them. Not too technical, but I
> now have a visible signal when sampling...it seems to have worked.
>
> When sampling I can however only see the signal in the vu mode...I can't
> heard anything. Should I be able to hear the audio passing from my
> turntable, through the emax, prior to sampling? I can only hear the signal
> after I've sampled, which obviously makes picking an exact spot on the
> record to sample a bit tricky!
>
> Not sure if there is a setting I've disabled, if this is yet another
> problem with my board, or something else.
>
> Any insight, as always, is appreciated greatly.
>
> Joel
>
>  
>


[Non-text portions of this message have been removed]