Emax

Any sources?  (other than Rapid, as they are prohibitively expensive outside the UK, almost
tripling the cost of the diplay in shipping)

I was planning to use a LED backlight one (modern ones are only about 1mm thicker,
not 9mm).  But it has the connector on the tall side so it is more work.


Op 29 jan. 2012, om 21:55 heeft jammie het volgende geschreven:

> use an oled they are direct replacements no need for pin 3 as there is no 
> angle and no need for back light just unsolder old display
> 
> and solder new one in place you will need to add a nut and bolt due to there 
> only being one solder side connection
> 
> this is the easyist oneto do as the vfd need hard wiring and are thicker
> 
> dont go led backlight route as these are 9 mm bigger than original and there 
> is a lot of fiddling around.
> 
>  
> 



[Non-text portions of this message have been removed]