Emax

--- In emax@yahoogroups.com, "jammie" <jammie.emma@...> wrote:
>
> yes and no if you dont have one then you need to cut the lcd and the connector so that you can desolder 1 pin at a time

1) I'm not 100% sure where this refers to? Desoldering pump, right?
 
> if you want to keep the connector then a desoldering station is required as you need to desolder the pins on the old lcd

2) That is the red small box where all those 16 pins go in, right? So that means I have to desolder them from the display unit so that they're still on the pcb fixed by the red connector box AND THEN soldering them to the new display (sounds easier than I thought before...) BUT ARE THE POSITIONS OF THE CONTACTS PARALLEL?
 
> as for colour there is only yellow that i know of in the oled versions

> if you want blue then vfd will be best but is more work involved and are a little hight in hieght is it going into a rack or keyboard

3) KEYBOARD (EMAX II TURBO)

> as a keyboard you can cut holes in the pcb as the traces are directly behind the lcd panel [[[but on the rack they re not and so you can cut o hole for the large piece on the back that stops the vfd from sitting close to the pcb]]]

4) Am I right when I say VFD diplays are much more expensive? They look cool and I'd prefer a VFD... BUT concerning the VFD the position of the contacts aren't the same so that I have to use wires, right? Furthermore I hope that I don't have to "rape" the emax case...

DO YOU HAVE A LINK JAMMIE EMMA WHERE YOU WOULD BUY YOUR DISPLAY (OLED;VFD)? 

THANK YOU VERY VERY MUCH!!!!!