Emax

Depends on the drive model


On Mon, Jun 4, 2012 at 1:20 PM, freddy1771994 <freddy1771994@...>wrote:

> **
>
>
> Thank you for the fast answer. Where can I change the jumper?
>
>
> --- In emax@yahoogroups.com, Ted Summers <djtbs1@...> wrote:
> >
> > Emax 1 uses SCSI ID 0 for the CF drive.
> > Emax 2 uses SCSI ID 1 or higher- did you change the jumper?
> >
> > If not- that would be a reason why.
> >
> >
> > On Mon, Jun 4, 2012 at 12:50 PM, freddy1771994 <freddy1771994@...>wrote:
> >
> > > **
>
> > >
> > >
> > > Hi,
> > >
> > > I bought an Emax 1 with cf card reader and slim floppy drive from group
> > > member jammie.emma which works fine. But in consideration of the fact
> that
> > > I have 5gb of emaxII (working with zip100 can be annoying then), but
> only a
> > > few hundred mbs of emaxI sounds (the internal ZIP I bought doesn't work
> > > eiter - but that's a different sory) I wanted to mount the cf card
> reader
> > > into the emaxII.
> > > I did so, but it doesn't work.
> > >
> > > It's easy to describe:
> > >
> > > 1) The emaxII simply does not see it or react on it, if the cable is
> right
> > > round on the pcb.
> > > 2) I hoped, "ok maybe it's the other way round than I used to have it
> > > installed when the harddrive was in." I did it and now all the lights
> were
> > > continously lit. After having it switched on and booting from the
> floppy
> > > the display completely refused any kind of work and it's turns black
> after
> > > the "Loading Software" message.
> > >
> > > No worries; I didn't mess it up. When I put it into the emax I angain
> it
> > > worked fine.
> > >
> > > Do you have any ideas where this problem might result from?
> > >
> > > Thank you very much!!!!
> > > Freddy
> > >
> > >
> > >
> >
> >
> > [Non-text portions of this message have been removed]
> >
>
>  
>


[Non-text portions of this message have been removed]