Emax

OK:

I found out how to change the id.

Let's say you're looking on it from its backside.

On the left there are the possiblities to change the write protection (no jumpers set) - That's not needed

On the right are the id jumper settings. It looks like this ::
                                                            ::

The top two pins are the termination; it is switched on with one of these jumpers, but i don't know which conection I have to make to select the correct id. Furthermore I have no jumpers at home....

Thank you!



--- In emax@yahoogroups.com, Ted Summers <djtbs1@...> wrote:
>
> Depends on the drive model
> 
> 
> On Mon, Jun 4, 2012 at 1:20 PM, freddy1771994 <freddy1771994@...>wrote:
> 
> > **
> >
> >
> > Thank you for the fast answer. Where can I change the jumper?
> >
> >
> > --- In emax@yahoogroups.com, Ted Summers <djtbs1@> wrote:
> > >
> > > Emax 1 uses SCSI ID 0 for the CF drive.
> > > Emax 2 uses SCSI ID 1 or higher- did you change the jumper?
> > >
> > > If not- that would be a reason why.
> > >
> > >
> > > On Mon, Jun 4, 2012 at 12:50 PM, freddy1771994 <freddy1771994@>wrote:
> > >
> > > > **
> >
> > > >
> > > >
> > > > Hi,
> > > >
> > > > I bought an Emax 1 with cf card reader and slim floppy drive from group
> > > > member jammie.emma which works fine. But in consideration of the fact
> > that
> > > > I have 5gb of emaxII (working with zip100 can be annoying then), but
> > only a
> > > > few hundred mbs of emaxI sounds (the internal ZIP I bought doesn't work
> > > > eiter - but that's a different sory) I wanted to mount the cf card
> > reader
> > > > into the emaxII.
> > > > I did so, but it doesn't work.
> > > >
> > > > It's easy to describe:
> > > >
> > > > 1) The emaxII simply does not see it or react on it, if the cable is
> > right
> > > > round on the pcb.
> > > > 2) I hoped, "ok maybe it's the other way round than I used to have it
> > > > installed when the harddrive was in." I did it and now all the lights
> > were
> > > > continously lit. After having it switched on and booting from the
> > floppy
> > > > the display completely refused any kind of work and it's turns black
> > after
> > > > the "Loading Software" message.
> > > >
> > > > No worries; I didn't mess it up. When I put it into the emax I angain
> > it
> > > > worked fine.
> > > >
> > > > Do you have any ideas where this problem might result from?
> > > >
> > > > Thank you very much!!!!
> > > > Freddy
> > > >
> > > >
> > > >
> > >
> > >
> > > [Non-text portions of this message have been removed]
> > >
> >
> >  
> >
> 
> 
> [Non-text portions of this message have been removed]
>