Emax

Hi Ted,

Thanks for the info. I opened up the unit and it doesn't have any of the SCSI options.

1) Eprom is IP349
2) TIM Pal IC's do not support SCSI
3) No 5380 Controller at IC6

Looks like I need an earlier version of the Operating Software. Any suggestions how to create a start up suitable disc using EXMP. I've got an old XP PC that can run EXMP so could I create an Operating Disc from this?

Cheers,

Bill


----- Original Message -----
From: Ted Summers <djtbs1@...>
To: emax@yahoogroups.com
Cc: 
Sent: Thursday, 27 September 2012, 16:54
Subject: Re: [emax] New Emax owner

HD OS 1.1 expects you have SCSI.
Usually if you have a wrong OS you will get "Wrong Software Rev" or similar.

If you have SCSI you could use HD OS 1.1 or PLUS OS 1.0 (which supports
external SCSI devices as well as an internal).

Check if you have it by reading here:
http://djtbs1.wordpress.com/2011/09/15/scsi-kit-do-i-need-one/

Regards,
Ted


On Thu, Sep 27, 2012 at 6:50 AM, darkbill_uk <darkbill_uk@...>wrote:

> **
>
>
> Hi,
>
> I've just purchased an Emax. I'm not sure which model I've got though. I
> was told it was a Series 1. There is a floppy drive but no HD that I can
> see, and it doesn't say SE anywhere.
>
> It came with two discs with the operating system on - Emax HD OS 1.1 - but
> when I put them in the drive doesn't recognise them. It starts spinning and
> then says "Disk Not Formatted".
>
> Having read some of the group posts I'm guessing I'm using the wrong
> operating system.
>
> I opened the Emax up and got the following off the board - EMAX CPU
> (1986). PC327. Version 2 REV C.
>
> Does anyone have any idea which operating system I should be using?
>
> Cheers,
>
> Bill
>
>  
>


[Non-text portions of this message have been removed]



------------------------------------

Emax and Emax II User's Group Website

http://www.silveriafamily.comYahoo! Groups Links



[Non-text portions of this message have been removed]