Emax

i use a flux core solder non rosin flux none clean
  ----- Original Message ----- 
  From: jammie 
  To: emax@yahoogroups.com 
  Sent: Sunday, October 14, 2012 4:41 PM
  Subject: Re: [emax] Solder skills


    
  use a continuity meter with a ring sound 

  plus you should get near zero ohms resistance as its a small short cabble

  you need to tape doen the cable so it does not move 

  its also better if you remove the old solder and clean the joint with some solder brade with none clean flux

  then place the cable next to the pin tape in place and solder 

  with a 0.5mm solder as if its to thick you will over solder it

  then solder together making sure it flows properly onto the pad and pin and cable

  repeat for the other 3 connections 

  bell out with continuity meter to make sure you have a circuit if it rings loud and clear you have a good joint connection between both point
  ----- Original Message ----- 
  From: dawtechie 
  To: emax@yahoogroups.com 
  Sent: Sunday, October 14, 2012 4:33 PM
  Subject: [emax] Solder skills

  Having trouble soldering wires to a JM215A. Are there any tricks like using flux? The areas involved are so tiny I bought a magnifying glass but still having trouble.

  Also when completed should I test the pin outs with a multimeter? What should I be looking for?

  Thanks! Jeff

  [Non-text portions of this message have been removed]



  

[Non-text portions of this message have been removed]