Emax

and Unknown Disc Format Error box.

that says

"unknown error processing message C0000014 Parameters 75b6bf7c 75b6bf7c "

This all happened before I removed the OmniFdd.sys driver and rolled

back to the standard windows FDD controller

Omniflop had problems with it too. I then went into OmniFlop and formatted

a floppy within it, after rolling back the OmniFdd Floppy Controller Driver

and I did get OmniFlop to actually see the floppy and format it.

I did a 'test installation' using OmniFlop and got a message reading drive good and it "supports 281 predefined formats yada yada"

I then did a 'Format Write routine using the Plus OS disk as the source

and it did go through the routine and Formatted as well as wrote the disk.

I then did a 'test disk' diagnostic with OmniFlop and it tested out ok

"format Recongnized"

I then placed it into the Emax I HD Fdd and cold booted

and it says "disk not formatted!"

I then formatted the Floppy on the Emax I HD and booted it just the same

to see if the Emax was indeed writing the disk correctly and it was.

I then took the FDD out of the Emax, Formated and function

and put it in my PC and started EMXP

I went to Emax disk utilities to 'Manage OS on Floppy Disk'

and got same error code dialog box

and same error code happens again

"unknown error processing message C0000014 Parameters 75b6bf7c 75b6bf7c "

I don't know what

"unknown error processing message C0000014 Parameters 75b6bf7c 75b6bf7c "

means to be quite honest..clueless here...

Think I will download EMXUTIL and see if that will fare better than EMXP is on this system as right now EMXP doesn't like my system for some reason