Mailist to discuss all issues regarding the Digitech GSP-2101 Guitar FX Processor

it sounds like the other owner pulled the 2nd ppc out
and didn't do a master reset.

try that.


--- telecasterkid <telecasterkid@...> wrote:
> Hello all,
> I just bought a 2101 off Ebay and received it
> yesterday. The packing 
> job wasn't the best but adequate I assume. Forgive
> me if am asking a 
> retorical question here but I have searched all 428
> messages looking 
> for an answer to my issue before I posted.....So
> here goes. It is 
> circa '95 that has been upgraded to Artist 3.00 a
> software, single 
> PPC. When I turn it on it goes through the startup
> procedure and 
> then sometimes loads to program 1, other times P80
> (flashes), 240 
> and so on. If it does happen to laod to program 1 as
> soon as I grab 
> the dial and turn it to ascend to 2,3 and so on it
> does this 
> computer code thing, says "I need a PPC" on P3 and
> then proceeds to 
> reboot? If I do a factory reset all is well until I
> change 
> parameters on any program then as soon as I shut it
> off and turn 
> back on again the same routine starts all over
> again. This is 
> actually my second 2101, I stupidly sold off my
> first one for a POD 
> Pro....Yea I know what the hell was I thinking!!!
> 
> If any if you folks could offer some advice as to
> where to proceed 
> from here I would greatly appreciate it. I haven't
> let the seller 
> know as of yet because I wanted advice first and
> then I would 
> proceed with either him or UPS for damage to the
> unit....
> 
> Thanks in advance,
> Sincerely,
> Kevin Schertell
> 
> You can reach me at the following:
> telecasterkid@...
> kevin.schertell@...
> 
> 
> 
> 



	
		
__________________________________
Do you Yahoo!?
Yahoo! Tax Center - File online by April 15th
http://taxes.yahoo.com/filing.html