Mailist to discuss all issues regarding the Digitech GSP-2101 Guitar FX Processor

James,

I also replaced fairly recently my ART X-15 controller for the FCB. 
It's working nicely.

If you want to calibrate the exp pedals (I didn't have to), read the 
FCB manual for instructions.

But on the other hand, check the following:
ON THE FCB:
- Pick the patch number you want to use, probably matching that on 
the GSP.
- Enter edit mode by pressing and keeping for 3 seconds the 'down' 
pedal. The green edit led should go on.
- Press the'up' pedal. You should see those controllers currently 
programmed lighting up, represented by each one of the pedals. Some 
might be off. Most likely, 8 and 9 (indicating the exp pedals) should 
be on.
- Press either 8 or 9, depending on which one you want to use. 
Press 'up' pedal (enter)
- The two-digit red display shows the controller number currently 
selected. Change it if you want (use the exp pedal to toggle the 
value), if not, just leave it as is, doesn't matter much. 
- Press 'up' and you get to the LOW value. Make sure it's 0 (exp 
pedal again).
- Press 'up', you get to the HIGH value. Make sure it is 127.
- Press 'up' again twice, set-up is complete. Now keep 'down' pressed 
for three seconds to get out to normal operation.

ON THE GSP:
- Select the patch you want.
- Enter the MIDI edit mode (MIDI key on the front panel)
- Navigate to LINK (hit 'next' once). Press '1' to link the parameter 
selected.
- Use the selector to toggle the controller as to show CCxx, xx being 
the same number that you had on the FCB.
- SAVE!!!

It should work now (this was all by memory, hope I didn't forget any 
step).

Gus.



--- In gsp-2101@yahoogroups.com, "jamesleehumes" <jamesleehumes@y...> 
wrote:
> 
> I bought this midi controller to use with my 2101.
> I can get it to change my patches but I cannot get the expression 
> pedals to work. They will not calibrate. I have searched the 
> archives but have found nothing. Can anybody help me with this 
> problem?