Lpc2000

This forum is for genuine questions and problems, plenty of people are 
here to listen and help as you yourself know quite well. I was a little 
entertained by your earlier complaints about Olimex but you may as well 
paint the whole industry with the same picky brush. Have you been sold 
defective goods? Have you been given a rock-solid guarantee that all 
documentation is 100% accurate? What don't you understand about VCC??? 
Are you a lawyer or something? What if Olimex said 3.3V instead of VCC 
and you found out it was sitting at 3.28V? End of the world?

Some of your complaints quoted below sound like a personal vendetta 
against Olimex.

rseku wrote:
> The currently released board LPC-P2138 has LED address 0x3000, and 
> BUTTON a address 0x18000. The schematic shows LED pins on 12,13 what 
> gives 0x1800 mask, and buttons on 15,16 (really is 16,17)
> On the CS8900 ethernet board, there significant inconsistencies between 
> schematic and board:
> 1. On board label D11 - On schematic no such label
> 2. On schematic R11 installed - on board not
> 3. On schematic connector pins exist as C2.1 -> c2.16, on board 17 -> 32
> 4. On board only top side has parts labels, bottom parts is you secret
>
>
> Do You take responsibility for these inconsistencies in case of 
> potential board damage caused by them?
>   

> I forgot to mention, that schematic contain supply voltage as misterious 
> VCC, which can mean any value !!!
> I received response from olimex support, that they don't know what is 
> all about!

What is this? Are you trying to tell us that you are genuine Robert?

Frankly, we don't know what your problem is but this is not the place 
for this kind of mudslinging.

nowaywhatsoeverassociatedwitholimex
*Peter*