Lpc2000

Newb - I can't seem to get my wiggler compatible to talk to my olimex 
proto board.  I've tried it on 2 laptops, 800 mhz and 2.8 ghz machines, 
various parallel port speed settings.  I'm using OCD Commander and 
always get an Internal Error 43 message, then "Error Response from 
INITIALIZE: 0x03 initialize_target : cable disconnected  (10 : 03)"  
I'm using OCD Commander 2.4.1 that comes with IAR jumpstart compiler.

I've followed posts warning about system speed, about making sure pins 
8 and 15 are shorted on the wiggler, about making sure the debug jumper 
is installed, about making sure the parallel port is not set to ECP - 
all verified yet nothing seems to work.  Shouldn't I at least be able 
to start OCD Commander with no warning messages and use it to reset the 
board even if the default flash-based program it was shipped with is 
still on it?  The default program appears to work just fine when the 
JTAG cable is disconnected.