Lpc2000

--- In lpc2000@yahoogroups.com, "ntfreak2000" <ntfreak2@h...> wrote:
>
> --- In lpc2000@yahoogroups.com, "lynchzilla" <lynchzilla@a...> 
wrote:
> >
> > May I add some additional points about the wiggler-jtag isssue.
> > 
> > I wrote a tutorial titled "ARM Cross Development with Eclipse" 
that 
> > is referenced in the "links" section of this message board. This 
> > tutorial shows in excessive detail how to set up a free GNU 
> compiler 
> > set for the ARM using the Eclipse/CDT IDE and how to use the 
> Eclipse 
> > debugger with the wiggler. Hopefully, you have had a look at that.
> > 
> > The obvious shortcoming is that it couldn't debug in FLASH memory.
> > 
> > I'm now furiously working on a revision to this tutorial that 
does 
> > show how to debug in FLASH. Thanks to the genius of my new co-
> > author, Norwegian engineer Kjell Eirik Andersen, we now have a 
> > simple utility program, RSPBreakout.exe, that reads all commands 
> > intended for the Macraigor OCDRemote and converts all 
> Z0,addr,length 
> > commands (software breakpoints) into Z1,addr,length commands 
> > (hardware breakpoints). As long as you limit yourself to setting 
no 
> > more than two breakpoints at a time, it will properly break in 
> FLASH 
> > and all single-stepping, variable inspection, etc works 
> > magnificently. This requires Macraigor's OCDRemote version 2.14 
> > which supports -Z2 GDB remote serial protocol commands.
> > 
> > Not the ultimate solution, but a great breakthrough for a 
> completely 
> > free development system nonetheless.
> > 
> > One last point, I can get the Olimex Wiggler to run at speed 3 
(140 
> > khz) using the latest OCDRemote ver 2.14
> > 
> > However, I found that certain Windows applications, such as my 
> > beloved SKYPE internet phone system, used so much of my CPU 
> > resources that the speed that the Wiggler could run was severely 
> > degraded (to the lowest speed). I suggest that you bring up 
Windows 
> > Task Manager and make sure that you don't have any applications 
> like 
> > that running. Remember that the OCDRemote/wiggler is 
> ssentially "bit-
> > banging" the parallel port and this LPT1 port probably has a much 
> > lower priority on the Windows driver pecking order. 
> > 
> > I hope to have the tutorial finished in the next several days. 
I'm 
> > also hoping that the Eclipse foundation may accept my tutorial as 
> an 
> > official Eclipse Corner article.
> > 
> > Cheers,
> > Jim Lynch
> >
> 
> You mention a utility RSPBreakout.exe that converts the soft 
> breakpoint requests to hardware for the ocdremote, this is what the 
> new monitor softbkpts command does.
> As single stepping/stepping and breakpoints within insight work 
> fantastic with monitor softbkpts off command.
> 
> Regards
> sjo
>
Thanks, Sjo.

Is that an OCDRemote command, GDB command or Insight command? Where 
is it documented? It may be just what I've been looking for.

Jim Lynch