Lpc2000

Hi John,
   
  Your mail has releived me. I thought i was the only one to face problems with the SPI of phillips. I was facing a similar problem like yours. I have been able to solve the problem partly.
  i.e.
  1. The miror image problem. can be solved by using the opposite modes in the master and slave side i.e if master is MSB the slave should be LSB.
   
  I am still facing a similar problem like yours, which i have not been able to solve as yet.
  I am unable to get the SPI working on power up reset, i.e all the other peripherals work perfect other than SPI. I have used SPI interrupts, & I have to short the reset pin momentarily to ground and reset the controller to make the SPI start working. I hope some one can help me with this problem. 
   
  SPI is really nagging me. Its been over a month now, and i have not been able to get the SPI work on power UP.
   
  Regards,
  Jerome
   
  

johnleerberg <johnleerberg@...> wrote:
  Hi All
      I have been working with the LPC2138 for about 12 months on and 
off and have had NO problems with getting any of the peripherals 
working until now. 

I have two LPC2138's connected via SPI0 and am intending to setup one 
as a master and the other a slave that adds two serial ports to my 
master.

There are two issues:

1) With MOSI to MOSI, P1.24 (master) to SSEL0 (slave), SCLK0 to SCLK0 
and MISO floating i am seeing a mirror of what is being transmitted 
by the master on the MISO pin of the slave????? And i mean a perfect 
mirror with no time shift, with the 4 channel CRO i am using i can 
overlay one waveform ontop of the other and they match perfectly. Yes 
i have put a multimeter across the pins to check for conductivity and 
no there is no solder across the MOSI and MISO.

2) I can get the SPI interrupt the fire on both the master and the 
slave but randomly the master will just lock up (something i have 
never had happen before). Also the upon power reset the SPI wont 
start but the serial port start perfectly everytime.
My program has three basic sections
a) In main i call an init interrupt routine which initialises the SPI 
port on the master.
b) In my ISR i read the S0SPSR (clear it), write 0xA0 to S0SPCR, 
clear the interrupt by writing 0x01 to S0SPINT, clear the VicVectAddr.
c) In main i write 0x5A to S0SPDR then wait 4ms and repeat (while(1) 
loop)

If anyone can help me it would be greatly appreciated.

   





  SPONSORED LINKS 
        Microcontrollers   Microprocessor   Intel microprocessors     Pic microcontrollers 
    
---------------------------------
  YAHOO! GROUPS LINKS 

    
    Visit your group "lpc2000" on the web.
    
    To unsubscribe from this group, send an email to:
 lpc2000-unsubscribe@yahoogroups.com
    
    Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 

    
---------------------------------
  



				
---------------------------------
 Jiyo cricket on Yahoo! India cricket
Yahoo! Messenger Mobile Stay in touch with your buddies all the time.

[Non-text portions of this message have been removed]