Lpc2000

I do have PLL code (which does work when enabled), but I've been
running most all of the debugging with the PLL disabled (removing
calls to config PLL with "#ifdef USE_PLL") because of this problem. 
So this problem actually crops up while running with straight crystal
speeds (12.288MHz).

--- In lpc2000@yahoogroups.com, "Danish Ali" <danish@...> wrote:
>
> If you single-step through the setup routine for the PLL, it is
possible that this
> kills the PLL  feed sequence and you'll probably be running at the
crystal frequency.
> 
> I haven't tried this, but it's what I would expect. (The manual says
the feed
> sequence must occur in consecutive VPB bus cycles.)
> 
> Regards,
> Danish
>