Lpc2000

Hi Jeff,

> I'm developing with the LPC2220 processor, using IAR's Embedded
> Workbench (4.30A and J-Link.  For some reason, about 30% of the time,
> when I run code in debug mode (using C-Spy) my timer and/or processor
> clock runs at incorrect speeds.  Yet when I end the debug session, low
> assert the reset pin on the processor, and let it boot up using the
> code in flash, all clock speeds will run at the correct speeds.  Is
> there a register in the processor or a setting in the IAR Embedded
> Workbench that I'm missing that would fix this problem?

Check under Linker settings, and verify "Buffered terminal output" is
unchecked. 


Joel