Lpc2000

Thanks Richard

actually i wanted to avoid any Interrupt routine.
anyway, i think i can use other interrupt status register bits also without
enabling them.

regards
Manisha.

-----Original Message-----
From: lpc2000@yahoogroups.com [mailto:lpc2000@yahoogroups.com]On Behalf
Of Richard Duits
Sent: Saturday, March 04, 2006 5:42 PM
To: lpc2000@yahoogroups.com
Subject: Re: [lpc2000] Polling for data reception


I don't know anything about the USB controller, because I never used an
LPC214x. All I know that you can poll if an interrupt routine would be
called if you enabled the interrupt, by reading the VICRawIntr register.

Regards,
Richard.


Manisha wrote:
> Hi Richard,
>
> thanks a lot for the reply.
> i was going through this VICRawIntr register. but, somehow i got confused
> about the bits. the 22nd bit is for USB, but, for which interrupt, is it
> specific for data in endpointOUT or it can be any inetrrupt. i could not
> find any specific about this. it will be helpful for me if you share
> something more about this.
>
> again thanks a lot.
>
> regards
> Manisha Kalita
>
>
>
> -----Original Message-----
> From: lpc2000@yahoogroups.com [mailto:lpc2000@yahoogroups.com]On Behalf
> Of Richard Duits
> Sent: Saturday, March 04, 2006 2:24 PM
> To: lpc2000@yahoogroups.com
> Subject: Re: [lpc2000] Polling for data reception
>
>
> You can always use the VICRawIntr register to poll the status of any
> interrupt, even those that are not enabled.
>
> Regards,
> Richard.
>
> Manisha wrote:
> > hi all,
> >
> > i am designing a USB driver code in LPC2148 board. whenever the USB port
> > receives any data, it generates an interrupt.
> >
> > However, i want to design my code by polling method, i dont want any
> extra
> > running context i.e an extra ISR. but as i found in the manual the
> bit in
> > the endpoint interrupt status register only indicates the reception. is
> > there any other bit or other CSR(Control status register) where i
> can get
> > indication for data reception and use that bit for polling?
> >
> > Thanks for going through the problem.
> >
> > please help me if anyone has any idea.
> >
> > Regards
> >
> > Manisha
> >




Yahoo! Groups Links






The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s)and may contain confidential or privileged information. If you are not the intended recipient, please notify the sender or administrator@...