Lpc2000

Hello,

some data aborts are ok, they're just a result of GDB trying to unwind the 
stack information when there actually isn't a stack frame. These shouldn't 
stop the OpenOCD from working.

What version of OpenOCD did you use? Were there other "Error:" messages in the 
daemon output? If your problem persists, you can send me a debug log (-d -l 
log.file).

Regards,

Dominic

On Saturday 01 April 2006 23:00, yugandhar_vasi wrote:
> I am unable to debug the programs properly using Open OCD and Olimex
> cable + Olimex 2148 board. I get a lot of these messages when
> debugging. Sometimes it just recovers but after 10-12 attempts, it
> just doesn't proceed. Is it the same case with everybody or nobody has
> seen these messages so far at all? Everybody is able to debug properly
> without any problems for the program running in Flash and program in RAM?
>
> The same happens to me either I try to debug from flash or RAM. For
> RAM I enable soft breakpoints and for flash I use only onchip
> breakpoints. I use GDB (Insight).
>
> Error:   arm7_9_common.c:1628 arm7_9_read_memory(): memory read caused
> data abort
>
> Thanks
> Yug