Lpc2000

ya its lpc 2148 board
ARM7 running at 60MHz, flash of 512 KB, RAM with 32 KB + 8 KB Shared with
USB DMA & USB 2.0 Device controller (Full Speed)DMA supported. using gcc. &
yes some help from sample code, i dont remeber the source.

Regards,
Manisha

-----Original Message-----
From: lpc2000@yahoogroups.com [mailto:lpc2000@yahoogroups.com]On Behalf
Of ian.scanlon
Sent: Friday, April 07, 2006 6:36 PM
To: lpc2000@yahoogroups.com
Subject: [lpc2000] Re: Please help:: checking for data receive in USB
Endpoint


--- In lpc2000@yahoogroups.com, Manisha Kalita <manisha@...> wrote:
>
> Hi all,
>
> i am designing an USB driver in lpc2000 board.

lpc2000 board?? what hardware? compiler? using example code from
____? PC test application?



it is sending the data
> properly. however, during reception, i am checking if any data is
there in
> the deveice register RXPLENGTH. if there is any peacket, PKT-RDY
bit of this
> register is set. but, in my case, even though no data is sent from
the host,
> PKT_RDY bit is always set. i am using interrupt transfer and so
using
> logical endpoint as 1.
>
> i am really stuck in this big problem. its urgent. if anyone has
any idea
> please reply.
>
> thanks for going through the problem.
>
> Thanks & Regards
> Manisha
>
>
> The information contained in this electronic message and any
attachments to this message are intended for the exclusive use of the
addressee(s)and may contain confidential or privileged information.
If you are not the intended recipient, please notify the sender or
administrator@...
>







Yahoo! Groups Links






The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s)and may contain confidential or privileged information. If you are not the intended recipient, please notify the sender or administrator@...