Lpc2000

I'm trying to implement I2C communication with my Ashling LPC2106 
eval board, and to get started, I've been reviewing the Ashling Full 
example.  That project communicates with two I2C devices on the eval 
board, a 7-segment LED and a DIP switch.  The documentation 
indicates the 7-segment display is at I2C address 0x01 and the DIP 
is at I2C address 0x00.  However in the code, writes to the 7-
segment LED use an address data byte of 0x42, which I interpret as a 
slave address of 0x21 and a direction bit of 0 (for writing).  
Similarly, when reading the DIP switch, the address data byte is 
0x41, or a slave address of 0x20 and a direction bit of 1 (for 
reading).  Is this an error in the eval kit documenation, or must 
the high nibble in the address be set to 0x2 for some reason?

Thanks!
Bill