Lpc2000

Hi folks,

I'm trying to connect my (very first) LPC2294 target to my board using Cross 
Studio and an Olimex 20 pin parallel port JTAG interface. Crossworks only 
lists Macraigor 14 and 20 pin targets and this gives an error message saying 
it [Crossworks] can't identify the target. Should this driver work with the 
Olimex interface? 

I do have both voltages on the processor and AFAIK I have all the JTAG 
connectors correct. If it's of any relevance at all, I'm running under Linux. 
Also, I have the Olimex interface on the end of a screened parallel lead (how 
short is that ribbon cable? ;-) 

Many thanks,

Rob