Lpc2000

Leon Heller wrote:
 > course. Has anyone got the Chameleon to work with the Philips ARM chips?

Yep works fine in Raven mode with a lpc2124. Never tried Wiggler mode. 
There is a special Chameleon target for Philips LPCs in particular you 
must use, not the generic JTAG one that comes in the bundle. Grab off 
their website.
Lack of good h/w breakpoint support when used with ocdremote and Insight 
still very annoying.
I'm using the latest ocdremote.

Bill Knight wrote:

> This SOUNDS like the error that newer versions of OcdLibRemote return
> when they find a non-standard WIGGLER.  I believe Macraigor's products
> have a jumper between a couple of the parallel port pins that the
> newer versions of code are checking.  I do not know if Amontec has
> added that functionality to the FPGA firmware.  Others on the mailing
> list might be able to confirm either or both.  If that is the problem,
> you could either acquire an older version of OcdLibRemote or build a
> db-25 adapter to add the jumper.

Agreed. I think I also managed to get it with a laptop that had a 
Parallel port that didn't configure from BIOS properly into the right 
mode. This was back when I was mucking about with a home made wiggler, 
so it may not be relevant to the Chameleon.

-- 
Cheers,
Bruce
-------------------------------------------------------------------
     /\\\/\\\/\\\    /   /      Bruce Paterson
    /  \\\ \\\ \\\  /   /    Senior Design Engineer
   /   /\\\/\\\/\\\/   /   8 Anzed Court, Mulgrave, Vic, 3170
  /   /  \\\ \\\ \\\  /  PO Box 4112, Mulgrave, Vic, 3170, Australia
/   /    \\\/\\\ \\\/   Ph: +61 3 8561 4232   Fax: +61 3 9560 9055
       Tele-IP Ltd.      Email: bruce@...    Icq: #32015991
                         WWW:   http://www.tele-ip.com       VK3TJN
-------------------------------------------------------------------