Lpc2000

I followed the example from the Insiders guide from Hitex, but it
seems if it is designed only for the Keil ARM compiler. Also I suspect
it to have an error where ADCR should be ADDR.

Anyway the interrupt function doesn't get called, and I have no clue
why not. In the Keil example they make a change in the startup.s, but
doing that didn't solve the problem.

How do I set up the ADC to hardware mode, using the GNU ARM toolchain?

My program looks like this:

void AD_ISR (void)
{
	unsigned val, chan;
	static unsigned result[4];
	
	val = AD0DR;
	val = ((val >> 6) & 0x03FF);
	chan = ((AD0CR >> 0x18) & 0x07);
	result[chan] = val;	
}

int main (void) {

	//The ADC setup
	VPBDIV 	= 0x00000002;
	AD0CR	= 0x00270607;
	
	VICVectCntl0 = 0x00000032;
	VICVectAddr0 = (unsigned)AD_ISR;
	
	VICIntEnable = 0x00040000;
	
	IODIR1 = 0x00FF0000;       /* P1.16..23 defined as Outputs  */

while(1)
{

}


The vector table in the startup.s look like this:

Vectors:        LDR     PC, Reset_Addr         
                LDR     PC, Undef_Addr
                LDR     PC, SWI_Addr
                LDR     PC, PAbt_Addr
                LDR     PC, DAbt_Addr
                NOP                            /* Reserved Vector */
                LDR     PC, IRQ_Addr
                LDR     PC, FIQ_Addr

Reset_Addr:     .word   Reset_Handler
Undef_Addr:     .word   Undef_Handler
SWI_Addr:       .word   SWI_Handler
PAbt_Addr:      .word   PAbt_Handler
DAbt_Addr:      .word   DAbt_Handler
                .word   0                      /* Reserved Address */
IRQ_Addr:       .word   IRQ_Handler
FIQ_Addr:       .word   FIQ_Handler

Undef_Handler:  B       Undef_Handler
SWI_Handler:    B       SWI_Handler
PAbt_Handler:   B       PAbt_Handler
DAbt_Handler:   B       DAbt_Handler
IRQ_Handler:    B       IRQ_Handler
FIQ_Handler:    B       FIQ_Handler

Best Regards
Søren