Lpc2000

--- In lpc2000@yahoogroups.com, "mahlerweb" <peter.mahler@w...> wrote:
> --- In lpc2000@yahoogroups.com, "mahlerweb" <peter.mahler@w...> wrote:
> > --- In lpc2000@yahoogroups.com, "David Hawkins" <dwh@o...> wrote:
> > > 
> > > 
> > > > since friday, i try to make some simple examples work on a 
> > LC2294, 
> > > > (Olimex LPC-E2294) The examples work fine on a LPC2106 and a 
> 2194.
> > > > The LPC2294-Example from the Olimex-Web-page also works without 
> > > > problems, compiled by an IAR-Comiler. 
> > > > 
> > > > Has anyone an idea ???    
> > > 
> > > The startup code sets up stacks etc. You need to make sure that
> > > the startup code and the linker script has a memory map that
> > > is consistent with your device.
> > > 
> > > Dave
> > 
> > Thanks Dave,
> > 
> > i use different linker-scripts for 2106 and 2194, the startup-code 
> is 
> > the same. IMO the LPC2294 should work with the same linker-script 
> as 
> > LPC2194, or are there some more differences between these two 
> > devices ??? 
> > 
> > Is there anybody who can show me a working gcc project on 
> > LPC2294 ???   
> > 
> > Thanks, 
> > 
> > Peter
> 
> 
> Hello,
> 
> i think i got it work!!! The problem was, that the Boot0 and Boot1 
> pin at LPC2294 were connected to ground, so the examples and linker-
> scripts, designed for internal flash memory, couldn't start.
> 
> Thanks,
> 
> Peter

Hi Peter,

Im trying to make a simple led flasher working on my board using GCC &
a 2292, but anything I try, it does not work. The board and led
flasher code as been validated with crossstudio and are working
properly but I am unable to make it work with only GCC and a makefile.
The problem seems to be either in the startup code or the linker script. 

Would that be possible to take a peek at your linker script and
startup code? Are you able to make an interruption work with it?

To facilitate my work, I really need to get my code to compile with
gnu environment.

Thanks,

Jean-Francois