Lpc2000

Hi,

I've tried pullup resistors. This just ties the pin to 3.3 volts

Regards Alsig

knatarov wrote:

> --- In lpc2000@yahoogroups.com, "jensalsig" <alsig@g...> wrote:
> > I use a Olimex LPC2214 board and are having some problems.
> > When I run this code (see below) I have a few pins that don't "act
> > normal". When messuring on a working pin I see a square wave with a
> > duty cycle of ca. 20% and an amplitude of 3.3 V. When I messure on ex.
> > P0.2 I have the same duty cycle ratio but the voltage is only 200mV.
> > The defective pins are: P0.2, P0.3, P0.20, P0.27, P0.28 and P0.29.
> >
>
> use pullup resistor
>
>
>
>
> ------------------------------------------------------------------------
> YAHOO! GROUPS LINKS
>
>     *  Visit your group "lpc2000
>       <http://groups.yahoo.com/group/lpc2000>" on the web.
>        
>     *  To unsubscribe from this group, send an email to:
>        lpc2000-unsubscribe@yahoogroups.com
>       <mailto:lpc2000-unsubscribe@yahoogroups.com?subject=Unsubscribe>
>        
>     *  Your use of Yahoo! Groups is subject to the Yahoo! Terms of
>       Service <http://docs.yahoo.com/info/terms/>.
>
>
> ------------------------------------------------------------------------
>